Attaching The Equipment; Binocular Tube, Eyepieces And Objective Lens, Mounting - Zeiss KSK 150 FC Instructions For Use Manual

Preparations for use

Attaching the equipment

CAUTION
R045

Binocular tube, eyepieces and objective lens, mounting

CAUTION
R079
CAUTION
R045
R049
R050
R078
R080
Page 42
Risk of injury caused by parts falling down!
If components and accessories are mounted on or removed from the device
about the patient, which is not allowed, this can cause parts to fall, can cause
injury to the patient, and can cause infections.
• In general, components and accessories should be changed without the
patient, and always before a surgical procedure or examination.
Injury to the eye due to light radiation!
Looking into a light source through a tube, an objective lens or an eyepiece
may cause eye injury.
• Never look into a light source or the sun with a tube, an objective lens or
an eyepiece.
Risk of injury caused by parts falling down!
Due to collisions or incorrect installation, parts may fall down and injure the
patient.
• Observe the maximum admissible load capacity of the suspension arm.
See the warning label on the instrument head.
• Before every use and after re-equipping the system, make sure that bin-
ocular tube (2) is securely locked in position.
• Make sure that securing screw (5) and objective lens (1) have been firmly
tightened!
• Use adjustment knob (7) to re-adjust the balance of the suspension arm
after every change of the equipment.
• Check that the floor stand is secured in a steady position and can be piv-
oted without causing collisions.
• Bring the suspension arm to a position convenient for you and tighten the
adjustment knob (6).
• Loosen securing screw (5) by a few turns.
KSK 150 FC
Version 7.1
G-30-1158-en