Changing The Halogen Lamp - Zeiss KSK 150 FC Instructions For Use Manual

Care and Maintenance

Changing the halogen lamp

NOTE
R054
WARNING
R055
CAUTION
R089
Page 62
Risk of burns caused by hot lamp!
If you change the lamp shortly after it has failed, the lamp will still be very
hot. There will be a risk of being burned!
• Allow the lamp to cool down before removing it.
• Use heat-resistant protective gloves when replacing the lamp!
Electric shock!
In case of a technical fault, line voltage may be present at the lamp module.
If the user touches it, he can receive an electric shock.
• Always switch off the power switch before working on the lamp module.
• Switch off the system at the power switch (1).
• Open cover (3) of the halogen illumination on the carrier arm
by turning securing screw (4) counterclockwise until the cover can be eas-
ily folded downwards.
• Allow the defective halogen lamp to cool down, if required.
• Pull the defective halogen lamp out of the ceramic base (5).
Risk of burns caused by use of incorrect lamp!
If an incorrect lamp is used, unwanted radiation may be emitted, and this can
cause burns.
• Only use the halogen light indicated in the order data.
Make sure not to touch the lamp bulb or the inside of the lamp reflector
of the new halogen lamp.
• Insert the two contact pins of the new halogen lamp into ceramic base (5).
• Close cover (3) of the halogen illumination on the carrier arm:
fold the cover upwards and turn securing screw (4) clockwise until the
cover is firmly closed.
• Turn on the unit at power switch (1).
• Use adjustment knob (2) to set the required brightness.
KSK 150 FC
Version 7.1
G-30-1158-en