Changing The Fuse - Zeiss KSK 150 FC Instructions For Use Manual

Care and Maintenance

Changing the fuse

Page 64
The fuses are integrated in the power inlet socket for the power cable. To
change a fuse, proceed as follows:
• Turn off the system at the power switch.
• Unplug the power cord from the wall outlet.
• Unplug the power cable from the power inlet socket.
• Insert a pointed object (small screwdriver) under the flap (2) and pull out
the fuse holder (1).
• Raise locking lever (3) and pull fuse holder (4) out of fuse insert (1).
• Remove defective fuse (5).
Observe the correct fuse rating of the line fuse. The fuse rating depends on
the set rated voltage range. The possible fuse ratings are marked on housing
(7) below line connector (6). For the ordering data, please see the section on
"Spare parts"" on Page 75.
• Insert the new fuse (5) in the fuse holder and push the fuse holder (4) back
into its compartment (1).
• Connect the unit to line power.
• Turn on the system at its power switch.
1
2 3 4 5
KSK 150 FC
6 7
Version 7.1
G-30-1158-en