Zeiss KSK 150 FC Instructions For Use Manual page 69

KSK 150 FC
Version 7.1
G-30-1158-en
Component
Illumination equipment Lamp housing in carrier arm: Halogen reflector lamp
Power connection
Rated voltages,
adjustable
Rated frequency
Power consumption
Fuses
Electrical standard
The system has been designed for continuous operation.
Load
Device base of the colposcope floor stand
Weight
Column length
Maximum total weight Max. 60 kg (Colposcope floor stand with installed
Properties
12 V 100 W, manual lamp change. An integrated
fiber optic system (light guide) directs the light to the
colposcope.
Power connector on carrier arm: Only connect the
device to wall outlets which are properly equipped
with a protective ground conductor.
100/110/120/127/220/230/240 V
50Hz - 60Hz
200 VA (nominal)
See section on "Spare parts", Page 75
Degree of protection IP X0 according to
IEC 60529:1989+A1:1999+A2:2013
For an asymmetric load distribution on the colpo-
scope body, maximum 2.1 kg, i.e., adaptation of the
beam splitters, tubes, eyepieces, camera adapters,
etc. on one side. The asymmetric load distribution is
limited by the maximum load permissible on the tilt
joint in the instrument head.
When the load is distributed symmetrically on the
body of the colposcope, maximum 3.3 kg, i.e., adap-
tation of a micromanipulator on one side and adap-
tation of beam splitters, tubes, eyepieces, cameras,
etc. on the other. The symmetric load distribution is
limited by the maximum load permissible on the sus-
pension arm.
Approx. 39 kg
Approx. 0.65 m
safe workload)
System Data
Page 69