Step 24. Perform Pre-Delivery Checks; Drive Belts - MacDon R80 Unloading And Assembly Instructions

STEP 24. PERFORM PRE-
DELIVERY CHECKS
WARNING
Stop tractor engine and remove key before
making adjustments to machine. A child or
even a pet could engage the drive.
IMPORTANT
To avoid machine damage, check that no
shipping dunnage has fallen into cutterbar.
a. Perform the final checks and adjustments as
listed on the "Pre-Delivery Checklist" (yellow
sheet attached to back of this instruction) to
ensure the machine is field-ready. Refer to the
pages for detailed instructions as indicated on
the checklist.
b. The completed checklist should be retained
either by the operator or the dealer.
The majority of checks and adjustments
are performed
procedures.
inspections should be performed after the
set-up is complete.
A. DRIVE BELTS
Drive belt tensions have been properly set at the
factory and should not require any further
adjustment. Check as follows:
a. Open RH drive shield.
Form # 169080
PRE-DELIVERY CHECKS
NOTE
during the set-up
The following additional
b. Lifting roll drive belt tension is factory adjusted.
Hole in tensioner member should be visible.
c. Apply force of 51 lbf (22 N) to each deflector
drive belt at mid-span. Deflection of each belt
should be 0.12 in. (3 mm).
d. Open LH drive shield.
e. Apply force of 51 lbf (22 N) to each deflector
drive belt at mid-span. Deflection of each belt
should be 0.12 in. (3 mm).
42
16 FT ONLY
16 FT ONLY
(continued next page)
Model Year - 2010