Step 14. Pre-Delivery Inspection; Tire Pressure (Transport And Stabilizer Wheel Options); Wheel Bolt Torque (Transport And Stabilizer Wheel Options); Sickle Drive Box - MacDon Harvest Header D65 Assembly Instructions Manual

STEP 14. PRE-DELIVERY
INSPECTION
IMPORTANT
To avoid machine damage, check that
no shipping dunnage has fallen into
machine.
Perform the final checks as listed on the
"Pre-Delivery Checklist" (yellow sheet attached
to this instruction) to ensure the machine is
field-ready.
Refer to the following pages for detailed
instructions as indicated on the checklist.
IMPORTANT
The machine has been set at the
factory, and should require no further
adjustments.
However, perform the following checks
to ensure your machine will provide
maximum performance. Adjustments
should be made only if absolutely
necessary, and in accordance with
the instructions in this manual.
The completed checklist should be retained either
by the Operator or the Dealer.
A. TIRE PRESSURE (TRANSPORT AND
STABILIZER WHEEL OPTIONS)
Check tire inflation pressure.
If necessary, inflate as per following table.
YEAR TIRE
GOODYEAR
2006 and
WRANGLER
EARLIER
RT/S
2007 and CARLISLE
LATER and TITAN
IMPORTANT
Do not exceed maximum pressure
specified on tire side wall.
169603
PRE-DELIVERY INSPECTION
SIZE PRESSURE
205-75 40 psi
R15 (276 kPa)
ST205/75 65 psi
R15 (448 kPa)
B. WHEEL BOLT TORQUE
(TRANSPORT AND STABILIZER
WHEEL OPTIONS)
Check wheel bolt torque is 80–90 ft·lbf
(110-120 N·m).
6
Refer to bolt tightening sequence illustration
above.
C. SICKLE DRIVE BOX
CHECK OIL LEVEL WITH TOP OF
SICKLE DRIVE BOX HORIZONTAL
a. Position of plug (A) and breather (B) at sickle
drive box must be as shown.
b. Check oil level.
28
1
3
5
4
2
BETWEEN LOWER HOLE
AND END OF DIPSTICK
A
(continued next page)
B
Revision B