HID DTC1000M User Manual page 50

© 2012 HID Global Corporation
Using the Advanced Settings tab
Setting
Flipper Home Offset
Flipper Lam Height
Offset
Mag HI-Co Voltage Offset
Mag Lo-Co Voltage
Offset
OLED Contrast
(display contrast)
DTC1000/DTC1000M/DTC4000 Card Printer/Encoder User Guide (L001398, Revision 1.5)
Option
This is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been
calibrated this value may need to be adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)
This is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been
calibrated this value may need to be adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)
This option changes the voltage going to the magnetic
head. (Note: This is factory set and should not be
changed unless directed by a technician.)
This option changes the voltage going the magnetic head.
(Note: This is factory set and should not be changed
unless directed by a technician.)
Use this option to increase or decrease the contrast of the
printer OLED (if applicable).
All rights reserved
50