2=History; 3=Program Check - Honeywell Fire-Lite Alarms ES-200X Manual

Programming
3.7.2 History
PROGRAMMING
1=POINT PROGRAM

2=HISTORY

3=PROGRAM CHECK

Maintenance Screen #1
The History feature allows the operator to view control panel events which have been stored in a history file in memory and erase the
contents of the history file
Pressing 1 while viewing the History screen will cause the following screen to be displayed:
To view all the events which have occurred in the control panel since the history file was last erased, press 1 while viewing the Events
screen. To view only alarms which have occurred, press 2 while viewing the Events screen. To view events other than alarms, press 3.
The most recent event will be displayed on the screen. To view all of the selected events, press the up or down arrow keys to scroll
through the list of events. If no events have occurred, the display will read NO EVENTS IN HISTORY.
Pressing 2 while viewing the History Screen will cause the following screen to be displayed:
Pressing 1 while viewing the Erase History Screen will cause the message ERASING HISTORY, PLEASE WAIT to be displayed. The dis-
play will then return to the History Screen. Pressing 2 will cause the display to return to the History Screen without erasing the History
file.
3.7.3 Program Check
PROGRAMMING
1=POINT PROGRAM
2=HISTORY
3=PROGRAM CHECK
Maintenance Screen #1
The Program Check feature allows the programmer to view the zones which have been programmed to the Notification Appliance Cir-
cuits on the control panel but have not been programmed to Initiating Devices as well as other circuits with no input or output correla-
tions. Pressing 1 while viewing Program Check screen will cause a screen similar to the following to be displayed.
The example above indicates that NAC 1 has been programmed to Zones 025, 031, 044, 055 and 067 but no input devices have been pro-
grammed to any of these zones. Use the up and down arrow keys to view all the NAC zones without input assignments for both NAC 1,
NAC 2, NAC 3 and NAC 4.
Pressing 2 while viewing the Program Check screen will display a screen similar to the following:
The Zone No Input screen allows the programmer to view the zones which have not been programmed to at least one input device (not
including general alarm Zone 00). The example in the preceding screen indicates that Zones 005, 007, 009, 010, and 011 have been pro-
grammed to an addressable module (control module in this example) with an address of 001 on loop 1 but have not been programmed to
any input devices. Use the up and down arrow keys to view all the zones without input assignments.
102
Pressing 2 while viewing Maintenance Screen #1 will cause the following screen to be displayed:
1=VIEW EVENTS
2=ERASE HISTORY
History Screen
1=VIEW ALL
2=VIEW ALARMS
3=VIEW OTHER EVENTS
ERASE HISTORY
PROCEED?
1=YES
Erase History Screen
Pressing 3 while viewing Maintenance Screen #1 will cause the following screen to be displayed:
PROGRAM CHECK
1=NACS NO INPUT
2=ZONES NO INPUT
3=ZONES NO OUTPUT
Program Check Screen #1
NACS NO INPUT
NAC 1
025 031 044 055 067
ZONES NO INPUT
005 007 009 010 011
1M001
HISTORY
HISTORY
Events Screen
2=NO
ES-200X Series Manual — P/N LS10131-000FL-E:C 7/25/2018
Maintenance Programming Level