Network Functions - Panasonic AJ-PG50EJ Operating Instructions Manual

Network Functions

P2 Browser Function
 Starting the application (P2 Browser) from the Web browser
When the network connection with the mobile device or computer is established, start the browser on the mobile device or com-
puter and then start the application (P2 Browser).
1
Select "BROWSE" or "BROWSE(+CTRL)" in the
"HTTP SERVER" (➝ page 105) menu setting.
The P2 Browser function is enabled.
2
Start the browser (Safari or Internet Explorer) on the
mobile device or computer.
3
Enter the IP address set for the unit in the address
bar of the browser.
• Factory default setting: 192.168.0.1
4
Press the Enter key in the case of a computer and tap
the GO button in the case of an iPad or iPhone.
The Web application (P2 Browser) starts.
5
Enter the user name and password in the input screen.
Enter the value set for "USER ACCOUNT" (factory default
setting: guest) and the value set for "PASSWORD" (factory
default setting: p2guest) on the unit.
The connection is established when the screen in Figure 1
appears.
You can set a user account name and password in the
"USER ACCOUNT" (➝ page 105) menu setting.
You can register a new account, delete an account, or
change a password in the "ACCOUNT LIST" (➝ page 105)
menu setting.
The user account name can be up to 31 characters long
and the password can be from 6 to 15 characters long.
For information on P2 Browser, refer to Operating Instruc-
tions of P2 Web Application available from the following
website.
http://pro-av.panasonic.net/en/manual/index.html
72
Main Mode: Using the Unit Connected to a Network
Figure 1
Note:
• When "NETWORK SEL" is "WLAN," "4G/LTE," or "LAN," the
startup time when the power is turned on may be longer than
usual due to the network function starting.
• When "NETWORK SEL" is set to "OFF," the network function will
not be available.
• When the "NETWORK SEL" setting is changed, the change is
not applied until the unit is restarted. When the setting is
changed, it may take a while for the settings screen to close be-
cause the network service is restarted.
• The combination of the IP address, subnet mask, and default
gateway must be correct.
If the "CANNOT ACCESS GATEWAY!" warning appears as the
setup screen closes, contact your network administrator.
• When a default gateway and DNS will not be used, set the set-
tings to "0.0.0.0."
• DHCP and DNS may not operate properly in some network en-
vironments.
P2 Playlist Editing Functions
The following functions are supported.
• Editing/saving playlists
• Creating new clips from playlists (edit copy)
• SDI playback using playlists
• Displaying and editing metadata
• Adding and deleting metadata (shot marks and text mem-
os)
For how to change modes and other information, refer to "P2
Playlist Editing Mode" (➝ page 83).