Table of Contents
Advertisement
Note:
• The startup time after turning on the power may be longer due
to starting of the network.
• When you change the "NETWORK SEL" settings, the changes
will not be reflected until the unit is restarted. When the setting
is changed, it may take a while for the settings screen to close
because the network service is restarted.
• The combination of the IP address, subnet mask, and default
gateway must be correct.
If the "CANNOT ACCESS GATEWAY!" warning appears as the
setup screen closes, consult the network administrator.
• IP addresses from [192.168.255.0] to [192.168.255.255] cannot
be used because they are reserved by the system.
• When a default gateway or DNS will not be used, set the settings
to "0.0.0.0."
• DHCP and DNS may not function properly depending on the
network environment.
• Up to 20 connections are saved in the connection history. When
20 is exceeded, the connections are deleted in order from the
oldest.
• The status of the SSID connection destination list is current at the
time the list was displayed and is not refreshed automatically.
SSID Connection Destination List
a
b
a: Selection state
b: SSID
c: Presence/absence of connection history
d: Encryption method
e: Signal strength
• Display is in order from the strongest signal.
• The SSID with the check mark for the selection state is the
selected SSID.
• The H indication for the presence/absence of connection
history indicates an SSID for which connection history is
stored. Even if a connection destination is out of range, the
SSID is displayed on the last row of the list.
Use the up or down cursor to select an SSID and press the
[SET] button.
c
d
e
4G/LTE Mode
These settings are for connecting with a 4G/LTE USB modem.
1
Select "4G/LTE" in the "NETWORK SEL" (➝ page
105) menu setting.
When you change these settings, restart the unit if necessary.
2
When the menu "4G/LTE PROPERTY" (➝ page 107)
is enabled, select "4G/LTE PROPERTY ", and set
the items as necessary.
When the setting of "4G/LTE PROPERTY" is required for
the connected 4G/LTE USB modem, "4G/LTE PROPERTY"
will become enabled.
When following setting is required, enter the information
provided from the provider accurately.
APN:
Sets the APN (Access Point Name) provided by the pro-
vider.
USER ID:
Sets the user name provided by the provider.
PASSWORD:
Sets the password provided by the provider.
DIAL NO.:
Sets the phone number. For details, refer to instructions
provided by the provider to which you are subscribed.
3
Check the network connection.
Check whether the connection between the unit and the
4G/LTE network has been established.
If the network connection is correctly established, the net-
work status icon at the top right of the thumbnail screen
turns yellow and you can use the application for using the
network (FTP Client Function). (➝ "Using FTP Client Func-
tions" page 74)
Note:
• The startup time after turning on the power may be longer due
to starting of the network.
• When you change the "NETWORK SEL" settings, the changes
will not be reflected until the unit is restarted. When the setting
is changed, it may take a while for the settings screen to close
because the network service is restarted.
Main Mode: Using the Unit Connected to a Network
69
Advertisement
Table of Contents
