Panasonic AJ-PG50EJ Operating Instructions Manual page 115

SYSTEM > SYSTEM SETUP (Continued)
Item
When "EXTERNAL" on the "GPS" (➝ page 114) menu item is selected, this selects whether
the location data will be saved when the power on this unit is switched off.
HOLD:
Location data will be saved (held), and this data will be used when recording from the time
P.OFF GPS DATA
that this unit is powered on next until new location data is acquired.
CLEAR:
Location data will be cleared, and location data will not be recorded from the time that this
unit is powered on next until new location data is acquired.
HOURS METER
SYSTEM > HOURS METER
Item
OPERATION Displays the total time that the power of the unit has been on.
P.ON TIMES Displays the total number of times that the power of the unit has been turned on.
LCD Displays the total time that the LCD monitor of the unit has been lit.
FAN Displays the total time that the fan of the unit has been rotating.
VERSION
SYSTEM > VERSION
Displays the various versions of the unit.
Item
VERSION Displays the overall firmware version (representative version) of the unit.
MODEL NAME Displays the model name of the unit.
SERIAL NO. Displays the serial number of the unit.
NETWORK ID Displays the network ID of the unit.
UID Displays the unique ID of the unit.
OPTION MENU
SYSTEM > OPTION MENU
The option menu can be displayed by pressing the [MENU] button while pressing the [DISPLAY] button.
Item
Sets whether to use the function that switches the signal reference for the LCD display and output signals from the input
signals to the internal free signals. This functions only for HDMI input. This can be used if there is a discrepancy in the
frequency of the HDMI input signal and reception is not possible with the unit.
ON: Enables free signal reference mode.
OFF: Enables standard mode.
INT LOCK MODE
Note:
• Dropped frames, identical continuous frames, image overlap, and other problems may occur in the LCD display,
output signals, and recorded video.
• When the INT LOCK MODE function is operating, "INT LOCK" is displayed in the additional information display area
on the LCD monitor.
Selects the area of use for the unit. The following settings can be set in the "AREA SELECT" screen.
NTSC: Selects an NTSC area other than Japan.
AREA SETTING
NTSC (J): Selects Japan.
PAL: Selects a PAL area.
Settings and brief function description
Settings and brief function description
Settings and brief function description
Settings and brief function description
FREQ indications
59.94Hz 50Hz
_ is the factory default setting.
Setup Menu: Menu List 115