Table of Contents
Advertisement
Display of thumbnail warning information
Item
Message
CANNOT ACCESS!
CANNOT CHANGE!
CANNOT DELETE!
CANNOT FORMAT!
CANNOT RE-CONNECT!
CANNOT REPAIR IN
SELECTION!
CANNOT REPAIR!
CANNOT SAVE! FILE
Thumb-
NAME IN USE
nail
CARD FULL!
INVALID VALUE!
LACK OF CAPACITY!
MISSING CLIP!
NO CARD!
NO FILE!
NO COPY TO SAME
CARD!
NO INPUT!
NO SD CARD!
124
For Long and Trouble-Free Operation: Warning System
Description
The data cannot be accessed because, for ex-
ample, the content is corrupted.
The thumbnail cannot be changed for a text
memo that is indicated by a gray
the thumbnail could not be generated.
Deletion is not possible because the content ver-
sions do not match.
Formatting is not possible because of a problem
with the P2 card, etc.
Clip reconnection is not possible because, for
example, content that is not a clip spanning mul-
tiple cards is selected.
Some of the selected clip could not be repaired. Check the selected content.
Content that cannot be repaired is selected.
A configuration file with the same file name al-
ready exists on the SD memory card.
The P2 card or SD memory card is full.
The entered data is invalid.
There is not enough recording space left on the
card.
A shot mark cannot be added to a clip that spans
multiple P2 cards if all of the segments are not
available.
No P2 card or SD memory card is inserted.
The designated file does not exist.
Copying is not possible because the copy
source and copy destination are the same.
No data is input.
No SD memory card is inserted.
Restore the media and clips to their normal states be-
fore access.
Edit the settings or content to enable thumbnail dis-
because
play.
Match the device and content versions.
Check the P2 card.
Check the selected content.
Check the selected content.
Save the file under a different name.
Insert media with sufficient free space.
Enter data in a valid range.
Insert a card with sufficient recording space.
Insert all of the P2 cards on which the clip was record-
ed.
Insert compatible media.
Check the file.
Copy to a card that does not contain the selected
clip.
Input data and then set the setting.
Insert an SD memory card.
Measure
Advertisement
Table of Contents
