Table of Contents
Advertisement
Configure the settings relating to network [Network]
The settings relating to the network of the recorder are configured on the setup menu - the "Advanced setup"
menu - the "Network" page.
The "Network" page has [Basic], [e-Mail], [Panasonic alarm protocol] and [NTP/SNMP] tabs.
Configure the basic network settings [Basic]
The basic settings relating to the network can be configured on this tab.
Note:
•
Enter the address octets and port numbers right-aligned. (Example: When the port number is 80, enter
"00080".) The leading zeros are omitted here.
■ Network Setup [Camera/PC port]
Configure the network settings of the recorder.
[IP address]
The IP address of the recorder will be displayed.
To change the IP address, click the [D]/[C] button.
Default: 192.168.0.250
[Subnet mask]
Select the subnet mask in accordance with the
recorder's network environment. Enter in the same
way as the IP address.
Default: 255.255.255.0
[Default gateway]
Select the address for the default gateway in accord-
ance with the recorder's network environment. Enter
in the same way as the IP address.
Default: 192.168.0.1
[Line speed]
Specify the line speed for data transmission.
Auto: Line speed will be applied automatically.
100M-Full: 100 Mbps full-duplex
100M-Half: 100 Mbps half-duplex
10M-Full: 10 Mbps full-duplex
10M-Half: 10 Mbps half-duplex
Default: Auto
Important:
•
When the setup menu is closed after changing the
line speed, the recorder will automatically reboot.
■ DNS Setup
The settings relating to DNS (Domain Name System)
can be configured on this tab.
[DNS]
Determine whether or not to use the DNS.
Off: Does not use the DNS.
Manual: When using DNS, it is possible to search
IP addresses by host name.
Default: Off
52
Advertisement
Table of Contents
