Error Codes - Panasonic AJ-PG50EJ Operating Instructions Manual

Error Codes

Code No.
TURN POWER OFF
E-30
<P2 CARD>
TURN POWER OFF
E-31
<SYSTEM MODE>
SYSTEM ERROR
E-35
<CODEC>
SYSTEM ERROR
E-36
<P2 SYSTEM>
SYSTEM ERROR
E-37
<P2CS>
SYSTEM ERROR
E-39
<INITIALIZE>
E-50 BATTERY TOO LOW
Display of warning information
When a warning occurs, a message is displayed on the OSD display and information display.
Displayed message
CANNOT REC
CANNOT LOOP REC
CANNOT PLAY
120
For Long and Trouble-Free Operation: Warning System
Displayed message
Displayed when data cannot be recorded on a P2 card.
[Cause]
• The card is write protected.
• No more free space on the card.
• Recording was attempted on a card that cannot be used.
• Card status changed during recording.
• Recording was attempted when the unit was BUSY.
Displayed when data cannot be recorded to a P2 card while the "RECORD-
ING" (➝ page 97) menu item is "LOOP."
[Cause]
• The card is write protected.
• No more free space on the card.
• Recording was attempted on a card that cannot be used.
• Card status changed during recording.
• Recording was attempted when the unit was BUSY.
Displayed when playback was interrupted due to a clip error or other factor.
[Cause]
• Playback was attempted when there were no clips.
• Playback was attempted for a card that cannot be used.
• Other causes that prevent playback or stop playback.
• Playback was attempted when the unit was BUSY.
Description
Displayed when an error occurs in reading and writing card
data.
To continue operation, turn the power off and then back on.
System mode error
To continue operation, turn the power off and then back on.
CODEC microprocessor error
To continue operation, turn the power off and then back on.
P2CS microprocessor error (error notification)
To continue operation, turn the power off and then back on.
P2CS microprocessor error (communication disconnected)
To continue operation, turn the power off and then back on.
Video initialization error
To continue operation, turn the power off and then back on.
Displayed when the battery voltage is below the undercut
voltage.
Description
Operation
Card removal
error
Format
inconsistency
System error
System error
System error
System error
Low voltage
Deck operation
STOP
STOP
STOP