Panasonic AJ-PG50EJ Operating Instructions Manual page 100

TC/UB/CTL
REC/PB > TC/UB/CTL
Item
Selects the 12- or 24-hour format for the CTL counter display.
CTL DISPLAY ±12h: 12-hour format display
24h: 24-hour format display
Sets the operating mode of the internal time code generator.
REGEN:
Synchronizes the internal time code generator to maintain continuity with the last time code
recorded on the P2 card.
TCG MODE PRESET:
Starts recording from the value set with the [TC PRESET] button.
EXT:
Uses the external time code input from the TIME CODE IN connector or VITC or SLTC of the
video signal. Set the selection in the "EXT TC SEL" (➝ page 100) menu item.
Sets the operating mode for the user bits of the internal time code generator.
REGEN:
Synchronizes the internal time code generator with the last user bit recorded on a P2 card.
PRESET:
UBG MODE
Starts recording from the value set with the [TC PRESET] button.
EXT:
Uses the external UB input from the TIME CODE IN connector or VITC or SLTC of the video
signal. Set the selection in the "EXT TC SEL" (➝ page 100) menu item.
Sets the operating mode for advancing the internal time code generator.
REC RUN: Advances the internal time code generator only during recording.
RUN MODE
FREE RUN: Advances the internal time code generator while the power is on regardless of
the operating mode.
Sets the time code to use when an external time code is used.
EXT LTC: LTC of TIME CODE IN connector.
S/H LTC: LTC information added to the signals input to the SDI IN connector or HDMI IN con-
nector.
S/H VITC: VITC information added to the signals input to the SDI IN connector or HDMI IN
EXT TC SEL
connector.
Note:
When "S/H LTC" or "S/H VITC" is set and "SD SDI" is selected as the input video signal,
the VITC of the input video signal is used.
Sets whether to record the internal time code generator value in the VAUX area.
ON: Records the internal time code generator value.
OFF: Does not record the internal time code generator value. When the VITC information is
superimposed on the input video signal, that value is recorded.
Note:
When the "LINE&FREQ" menu item is set to "720-59.94P" or "720-50P," the operation is
VITC GEN
as follows.
• Time code data recorded in the VAUX area:
• User bit data recorded in the VAUX area:
Sets the drop frame mode or non-drop frame mode for CTL and TCG.
DF MODE DF: Uses drop frame mode.
NDF: Uses non-drop frame mode.
Selects whether to output VITC signals at the positions specified in the "VITC POS-1" and
"VITC POS-2" menu items during playback.
BLANK: Does not output a VITC signal.
THROUGH: Outputs VITC signals.
VITC BLANK
Note:
• This setting is enabled only during SD SDI output.
• In EE mode, the VITC signal superimposed on the input signal is output as is.
100
Setup Menu: Menu List
Settings and brief function description
Even if this menu item is set to OFF, the internal time code generator value is recorded
when VITC information is not superimposed on the input video signal
The frame rate information is always recorded regardless of the setting of this menu
item.
_ is the factory default setting.
FREQ indications
59.94Hz 50Hz
59.94Hz 50Hz
59.94Hz 50Hz
59.94Hz 50Hz
59.94Hz 50Hz
59.94Hz 50Hz
59.94Hz
59.94Hz 50Hz