Table of Contents
Advertisement
Displayed message
SIMUL REC WARNING <>
CHECK SLOT <>
LAN ERROR
UP LIST #99/100
UP LIST #100/100
UP LIST OVER MAX
INVALID TC MODE
INT SG
NO INPUT
INVALID INPUT FORMAT
HDCP EXISTED
Description
Displayed when an error occurs with one of the cards during simultane-
ous recording. ( is the slot number mark for indicating where the error
occurred.)
Recording will stop on the card on which the error occurred, but will con-
tinue on the other card.
The memory card may not be recognized correctly due to reasons such
as the microP2 memory card being inserted slowly or dirt on the terminal
of the memory card.
- Recording cannot be performed on the inserted microP2 memory
card.
- Check the microP2 memory card that is inserted. ( is the slot num-
ber mark for indicating where the error occurred.)
Displayed when the LAN connection or disconnection failed. To continue
operation, turn the power off and then back on.
If the message is displayed again, consult with your dealer.
The number of registrations in the upload list of the rec during upload
function has reached 99.
One more clip to the upload list can be registered. Delete unnecessary
clips in the upload list.
The number of registrations in the upload list of the rec during upload
function has reached the upper limit.
When more additional clips need to be registered, delete unnecessary
clips in the upload list.
Clips cannot be added for registration because the number of registra-
tions in the upload list of the rec during upload function has reached the
upper limit.
When additional clips need to be registered, delete unnecessary clips in
the upload list.
Displayed during playback when the time code has been recorded in
drop frame mode. The video output is distorted and audio output is muted
at the drop point of the time code. Check the playback clip.
Playing back a 24P frame-rate clip requires that the time code be record-
ed in non-drop frame mode.
Displayed when the time code in an HD SDI input is in the drop frame
mode during EE or recording. Normal recording will not be possible under
these conditions.
Displayed for the first two seconds when the [REC] button is pressed to
switch to EE mode while "INT SG" is selected in the "INPUT SEL" (➝ page
103) menu setting.
If there is no input signal to the connector selected in "INPUT SEL" (ex-
cluding analog audio), this is displayed for 2 seconds after you press the
[REC] button to switch to EE mode.
Displayed when the input signal of the connector selected by "INPUT SEL"
is a signal that cannot be received. The input signal is muted.
Displayed when an HDCP signal is detected while the HDMI input is se-
lected. Note that recording is not possible when an HDCP signal is de-
tected. SDI/HDMI and streaming video outputs are also not possible.
For Long and Trouble-Free Operation: Warning System
Deck operation
Operation
continues
Operation
continues
STOP
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
123
Advertisement
Table of Contents
