Connecting An External Device Via The Usb Host Port - Panasonic AJ-PG50EJ Operating Instructions Manual

Memory card portable recorder
Table of Contents

Advertisement

Connecting an External Device via the USB HOST Port

Supported storage devices
The following storage devices can be used.
• Hard disk drives or solid state drives connected via USB 2.0/USB 3.0.
Storage device types and available functions
The available functions depend on the type of storage device used. The storage device type is displayed below "PARTITION:"
on the left side of the EXPLORE screen.
(➝ "Viewing storage device information (EXPLORE screen)" page 60)
Note:
• When using this unit with the battery, externally supply power to any storage device connected to the [USB3.0 HOST] port.
• The USB 3.0 connector supports USB bus power (5 V, 0.9 A), but startup may not be possible depending on the storage device.
Should this happen, provide the storage device with a separate power supply.
• Storage devices over 2 TB (2018 GB) are not supported.
Storage device types and available functions
Storage
Features
device
type
TYPE S
A special format for
high-speed writing/
loading data on a
card basis.
FAT
A storage device
whose primary parti-
tion is formatted either
in FAT16 or FAT32. The
root partition or "CON-
TENTS" directory in
*
2
any folder
is used.
OTHER
Storage device other
than the above
• A storage device
with a file system
other than FAT16
and FAT32, such as
NTFS.
1
*
Adding clips to a partition will prevent writing back data on a card basis to that partition.
2
*
There can be up to three levels of folders and the maximum number of folders is 100. The folders appear in order from the top level.
Long file names and two-byte character file names are not supported.
Example:
/CONTENTS
/SAMPLE/CONTENTS
/SAMPLE/20090101/CONTENTS
/SAMPLE/20090101/1200/CONTENTS
3
*
Audio and video dropouts may occur during playback from a storage device depending on its performance and operating condi-
tions. Perfect playback cannot be guaranteed.
4
*
2 TB or larger storage devices cannot be formatted.
Thumbnail
P2 card basis
Display
P2/microP2
microP2
(≤32 GB) ➝
(>32 GB) ➝
Storage
Storage
Can be displayed
Can be displayed
Can be displayed
Cannot be displayed ➝ This is the fourth level and will therefore not be displayed.
Available functions
Clip basis
Storage ➝
Storage ➝
P2/
microP2 ➝
P2/
microP2
microP2
(>32 GB)
Storage
(≤32 GB)
1
*
Play-
Clip
Format
back
image
Storage ➝
*
3
check
display
P2/
microP2
Main Mode: Thumbnail Screen
*
4
57

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aj-pg50

Table of Contents