Table of Contents
Advertisement
Operating instructions
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
In the following chapter, figures are given in brackets to clarify what needs to be
done. These numbers refer to image and list above.
WD-8
Symbol for washing function. After the machine is started, the symbol lights
up when the tank is full. The symbol flashes if the water level in the tank is
too low.
Display for temperature during operation. When checking and setting
reference values, the display shows the number for the relevant reference
value, e.g. 01, 02, 03, etc. Together with display (4), it shows error
messages.
Final rinse indicator. The symbol is lit while the machine is filling up, during
the final rinse phase and when the cleaning programme is run after a
completed washing cycle. The symbol flashes if the hood is opened during
the washing cycle or if the final rinse water has not reached the correct
rinse temperature when the rinsing phase is due to start. The machine
continues washing until the correct rinse temperature has been reached.
Display showing the programme during operation, which counts down the
remaining washing time.
Button for closing or opening the hood. (On machines with an automatic
hood lift.) (option)
Button for washing programme 1. When the machine is in service mode,
P1 is used to show the different reference values and to reset the reference
values to the last saved values. If the machine has a drain pump, P1 is
used to start the drain pump and empty the tank after washing.
Button for washing programme 2. P2 is used in service mode to increase a
reference value or jump between tables. In shut-off mode the software
version number can be displayed by holding down P2.
Button for washing programme 3. P3 is used in service mode to reduce a
reference value or jump between tables. P3 is used in shut-off mode to start
internal rinsing when the cleaning programme is used to clean the
machine.
Button to switch the power on or off. This button is also used to reset
alarms, display the water flow to the machine and to move to service mode.
Rinse nozzle
"Autostart" (if the machine has this option, the hood is closed automatically
when a basket is loaded in the machine) (optional). (Not in combination
with (20)).
Tank filters
Level pipe (has been replaced by a bottom filter if the machine is connected
to a WD-PRM)
Rubber sleeve
Drain filter (on machines with a drain pump) (optional).
Pump filter
Washing and rinsing arm
Wash nozzle
Lever for normal/heavily soiled wash
Hinged grid shelf (option). (Not in combination with (11)).
31
Rev. 4.0 (202202)
Advertisement
Table of Contents
