Wexiodisk WD-8 Installation And User Manual page 52

Operating instructions
CODE CAUSE
Er16 The temperature in the booster heater is
too low.
Low level in the break tank.
Er23 The hood does not open when the
automatic hood opener is used.
Er27 The machine has lost all its set values.
IF30 Low water level in the washing tank
before washing.
The level pipe's rubber sleeve is leaking.
IF34 The detergent alarm.
The machine has run out of detergent.
IF35 The machine is started with the hood
closed.
Er96 The motor safety cut-out for the pump has
tripped.
Er97 One digital input is shorted to ground.
Er98 Communication fault between the CPU
and the panel card.
Er99 Communication fault between the
computer and panel cards.
WD-8
ACTION
The alarm can be reset by pressing 0/1 on the panel.
Contact service personnel.
The alarm can be reset by pressing 0/1 on the panel.
Contact service personnel.
The alarm can be reset by pressing 0/1 on the panel.
Contact service personnel if the fault recurs.
Contact service personnel.
Check that the level pipe is closed. The alarm can be
reset by pressing 0/1 on the panel.
Check that the level pipe's rubber sleeve has not been
damaged.
The alarm can be reset by pressing 0/1 on the panel.
Check the amount of detergent and refill, if necessary.
Open and close the hood to acknowledge the alarm.
Contact service personnel.
Contact service personnel.
The alarm can be reset by pressing 0/1 on the panel.
Contact service personnel if the alarm recurs.
The alarm can be reset by pressing 0/1 on the panel.
Contact service personnel if the alarm recurs.
48
Rev. 4.0 (202202)