Table of Contents
Advertisement
Installation instructions
When drilling holes, it is important that the following points should be observed:
•
Use sharp tools so that panels do not become unnecessary hot. Red-hot
panels can rust in the future.
•
Remove all metal shavings carefully both from the machine and tank
before refilling with water. Shavings left in the tank can cause corrosion.
Glas_tank
Connecting the detergent hose
Marking for measuring cell
E= Connection in the tank
F= Connection nipple
G=Marking in bottom of tank for measuring cell
For information about electrical connections, see the wiring diagram.
If equipment for a different type of detergent is used, it should preferably be put
on the wall behind the machine to avoid holes being drilled unnecessarily in the
machine.
The machine can also be equipped with detergent and drying agent equipment
via external connections. See the wiring diagram for the correct connection.
Holder for connections for detergent and drying agent
The process of setting the detergent and drying agent dispenser is described in
the ADJUSTMENT INSTRUCTIONS.
WD-8
F
E
G
17
Rev. 4.0 (202202)
Advertisement
Table of Contents
