Table of Contents
Advertisement
Installation instructions
Connection to the left- or right-hand side of the machine
1.
2.
3.
•
•
•
•
•
Use a spirit level to check that the sinks are horizontal and adjust the height, if
necessary.
WD-8
3
A
A
A - A
Water connection
Electrical connection
Floor drain
Attach the sink connection to the machine and then adjust.
Drill two ø 4.5 mm holes through the sink connection and the machine,
approx. 100 mm from each outer edge.
Countersink the holes.
Seal with silicone between the connection and the machine.
Secure the sink with countersunk M4 screws, grommets on the outside
surface and nuts. Alternatively, you can secure the sink to the wall with wall
brackets.
25
Rev. 4.0 (202202)
2
1
300730_R2b
Advertisement
Table of Contents
