Adjustments - Furuno FAR-2228 Installation Manual

3.

ADJUSTMENTS

Note: After completing the settings and adjustments, copy the setting data to a SD-
card* (USB flash memory* for C-type radars), referring to the Operator's Manual. This
will allow easy restoration of setting data after the MAIN Board is replaced, etc.
*: The SD card slot is in front of the Processor Unit, and the USB flash memory slot is
connected to the RP board 03P9657.
At the first start-up after installation, turn on
the Processor Unit with the main switch. Open
the protected menus to adjust the radar. Fol-
low the procedures in this chapter to complete
the adjustment.
**: For DC power specifications, the Processor
Unit does not have the main switch. To power
on the Processor Unit for DC power specifica-
tions, turn on the ship's Mains.
For FAR-2x58 radars, turn on the Power Sup-
ply Unit also with the main switch.
Note: Turn the main switch of the Processor
Unit off before turning the Power Supply Unit
off. Further, both units should also be turned
off at the ship's main switchboard.
Below are the controls on the Control Unit RCU-014/015(or optional RCU-016) that
are used to make the adjustments.
RCU-014
Power key HL OFF key
BRILL A/C RAIN A/C SEA
OFF ON
1 2
EBL HL EBL
OFF OFFSET
4 5
F1 F2 OFF CU/TM
CENTER RESET
7 8
F3 F4 VECTOR VECTOR
TIME MODE
0
ALARM STBY CANCEL
ACK TX
BRILL
TRAILS
Mouse wheel
Left button
GAIN
OFF ON
3
VRM
MODE
6
INDEX MENU ACQ
LINE
9
TARGET
+
TARGET
DATA
LIST
RANGE
TARGET
ENTER
MARK CANCEL
MENU key Track ball
MAIN SW
Main switch**
Main switch
Right button
3-1