Transceiver Unit - Furuno FAR-2228 Installation Manual

2. WIRING
For RW-4864 cable
(A) (A)
*: For cable for "input" signal of an external radar, connect to J710.
2.7

Transceiver Unit

The TR-DOWN radar requires the transceiver unit as follows:
• Transceiver Unit RTR-108 for X-band radar (FAR-2328W)
• Transceiver Unit RTR-109 for S-band radar (FAR-2338SW)
2.7.1 How to fabricate the cables
For how to connect the LAN modular plug, see "LAN cable" on page 2-5. For how to
connect the WAGO connector, see "WAGO connector" on page 2-6.
TTYCYSLA-10 (for serial cable)
Clamp the armor with the cable clamp.
Outer sheath Armor
2-54
(B) (B)
J710*
J708
J717
J709
(C) (C) (D) (D)
300 300
35 35
5 5
Drain wire Drain wire
Inner sheath
Vinyl tape
For RW-00136 cable (from upper entrance)
(E) (E)
140 140
6
Pass the heat shrink tubing (local supply)
onto the drain wire.
J708
J710*
(C) (C)
(D) (D)
(E) (E)
6
Crimp-on lug
(FV1.25-3(LF) RED for X-band,
FV1.25-4(LF) RED for S-band)
(unit: mm)