2. WIRING
Some parts or wiring have been omitted from the illustrations for clarity.
1. Loosen four bolts on the rear cover to remove the rear cover. If the de-icer is al-
ready installed or will be installed, remove also four bolts on the front cover to re-
move the front cover.
Note: The cable for the performance monitor is connected between the rear cover
and the RF-TB Board in the Antenna Unit. Open the cover slowly to prevent dam-
age to the cable and connector.
2. Disconnect the performance monitor connector (J807) from the RF-TB Board.
3. Unfasten the cable gland for the serial cable (TTYCSLA-10) and remove the gas-
ket and three flat washers and remove the protector.
2-42
REAR
REAR
Performance
Performance
monitor
monitor
REAR
REAR
RF-TB board (03P9570)
REAR
REAR
Cable entry for serial cable (Side view)
REAR
REAR
De-icer power cable
Microwave coaxial cable
Serial cable from the
transceiver unit
Antenna motor switch
FRONT
FRONT
For de-icer installation
J807 (performance monitor)
J807 (performance monitor)
Flat washers
Flat washers
Remove
Remove
Gasket
Gasket
Gland
Gland
protector
protector