Lan Signal Converter - Furuno FAR-2228 Installation Manual

2. WIRING
How to open the [INSTALLATION SETTING] menu
Turn off the monitor unit. While you hold the DISP key, press the BRILL key to turn on
the monitor unit. Keep the DISP key pressed until the [INSTALLATION SETTING]
menu appears.
Note: When the [DVI PWR SYNC] slide switch is ON, turn on the connected external
equipment while you press the DISP key to turn on the monitor unit.
2.10

LAN Signal Converter

The LAN Signal Converter allows the use of existing antenna cable RW-9600/6895/
4873 for TR-UP radar.
If the LAN Signal Converter is not attached in the antenna and Processor Units, the
required LAN Signal Converter Kit (available as an optional extra) is listed below.
For X-band radar only, you can select a specification with the LAN Signal Converter
pre-installed at the factory.
X-band magnetron radar
X-band solid state radar
S-band magnetron radar
S-band solid state radar
2.10.1 Application overview
The LAN Signal Converter has two applications.
Application 1: Use with existing antenna cable (retrofit)
Processor Unit side
Processor
Unit
* Installed inside respective unit.
Method 1: Using existing antenna cable (RW-9600/6895/4873)
Note: Use with existing antenna cable (RW-9600/6895/4873) in case of retrofit. The
maximum length of the antenna cable is 100 m for RW-9600, 50 m For RW-6895/
4873.
2-68
LAN Signal Converter Kit (option)
Radar
OP03-247-3
OP03-247-4
OP03-247-2
OP03-247-1
Power
Power
TB
LAN
Coaxial
LAN↔Coax
Converter*
Power
Type
Antenna cable
(Coaxial, Power)
RF-TB
LAN↔Coax
Converter*
Code No.
001-496-580
001-568-890
001-496-570
001-496-560
Antenna Unit side
Power
Antenna
Unit
LAN
Power