Furuno FAR-2228 Installation Manual page 73

Motor power cable
1) Pass the motor power cable as follows:
2) Connect the wires of the motor power cable to the Terminal board TB901 on
the front side through the appropriate wiring clamps, according to wiring stick-
er.
Front side Front side
Antenna cable
1) Pass the antenna cable as follows:
2) Connect the wires of the antenna cable to the appropriate WAGO connectors
(pre-attached on the RF-TB board).
Coaxial cable: TB902 on the TNC Junction Box, passing over the slide rail.
Signal lines: TB801, TB802 and TB803, passing over the slide rail.
Shield lines: Wing bolt, passing under the slide rail.
RF unit side RF unit side
3) Remove the TNC junction box from the RF unit and then connect the coaxial
cable of the antenna cable to the BNC case.
TNC junction box TNC junction box
Loosen two screws.
RF unit RF unit
4) Re-mount the TNC junction box to the RF unit.
Pass through the Pass through the
wiring clamps. wiring clamps.
• Signal lines
• Coaxial cable Slide rail
Shield
lines
Wing bolt
Fabricated coaxial cable
14 14
5 5
Folded shield* on the sheath.
*: For 03CA00099 cable, do not fold the
shield as shown in the figure to the right.
TB901 TB901
1 RED
2 BLK
3 WHT
RF-TB board (03P9665)
TB801 TB801
TB803 TB803
Fasten conductor with Fasten conductor with
screw. screw.
14 14
Fasten shield with clamp. Fasten shield with clamp.
14 14 14 14
5 5
2. WIRING
TB901 TB901
MOTOR_H
GND
MOTOR_C
TB802 TB802
2-19