Furuno FAR-2228 Installation Manual page 86

2. WIRING
14. DE-ICER INSTALLATION. See "De-icer Kit Installation Instructions" (for TR-UP
radar, C32-01313), issued separately, for the de-icer not fitted at the factory. If the
de-icer is not provided, go to step 12.
Front cover w/de-icer,
1) Remove four bolts then spread open
the right and left heater elements on the
front cover.
Note: Lift the elements slightly when
opening so as not hit the elements on
the bolts on the chassis.
2) Unfasten four bolts to open the front
cover. Remove the cover, being careful
not to hit the elements on the chassis or radiator.
3) Remove the RF unit then pass the de-icer power cable from the cable en-
trance.
4) Wrap the supplied spiral tube around the de-icer power cable, starting from
the crimp-on lugs. Set a locking wire saddle (supplied) at location (6) shown
in the following figure. Pass the de-icer power cable through the locking wire
saddles (1) to (6) and it to the front side.
2-32
inside view
REAR REAR
TB901
DEICER Board (03P9573)
[TEST] button
Voltage Setting
switch
Spiral tube