Furuno FAR-2228 Installation Manual page 157

4. INPUT/OUTPUT DATA
IMO-type radar(s) must be interconnected to the following type approved sensors.
For other radar types, it is recommended to connect the following type approved sensors:
• EPFS meeting the requirements of the IMO resolution MSC.112(73).
• Gyrocompass (or equivalent devices) meeting the requirements of the IMO resolution A.424(XI).
• SDME meeting the requirements of IMO resolution MSC.96(72).
The radar may be interconnected via HUB-3000 to other FURUNO processing units having approved
LAN ports.
4.1 Processor Unit
Input and output data are shown in the table below.
Note: This radar accepts position data fixed by WGS-84 geodetic datum only. Set the
datum to WGS-84 on the EPFS (GPS, etc.) connected to this radar. If other type of
datum is input, the error message "DATUM" appears and the AIS feature is inopera-
tive.
Input
Data
Heading
signal
Speed
signal
Navaid data
Alarm
handling
signal
AIS signal
Consort
signal**
GPS buoy
signal**
*: Data input cycle must be more than 40 Hz (high speed craft) or 20 Hz (conventional
ships).
**: For C-type radars only
NOTICE
Specification
AD-10 format External AD-100
IEC 61162-2*,
IEC 61162-450
IEC 61162-1,
IEC 61162-450
IEC 61162-1 Position, course, speed,
waypoint, route, time,
wind data, current data,
depth, temperature, roll,
pitch
IEC 61162-450
Contact closure
IEC 61162-1, ACK, ACM, HBT
IEC 61924-2
IEC 61162-2,
IEC 61162-450
NMEA0183
NMEA0183
Contents
AD-10 and IEC 61162
are switched by menu
setting.
For IMO-type, IEC-
61162-1 Edition 5 is re-
quired.
Input from bridge alert
management system
(BAMS)
Input from BAMS ACK
and ACM are switched
by menu setting.
Remarks
4-1