Antenna Unit For X-Band, Tr-Up Radar - Furuno FAR-2228 Installation Manual

2.2

Antenna Unit for X-band, TR-UP Radar

2.2.1 How to fabricate the cables
LAN cable
Expose inner vinyl sheath.
approx. 9 mm
Fold back drain wire and cut it,
leaving approx. 9 mm.
Using special crimping tool
MPT5-8AS (PANDUIT CORP.), crimp
the modular plug. Finally, check the
plug visually.
Remove the inner vinyl sheath by
approx. 25 mm. Be careful not to
damage inner shield and cores.
approx. 11 mm
Straighten and flatten the cores
in colored order and cut them,
leaving approx. 11 mm.
[Crossover cable]
WHT/ORG 1
1 WHT/GRN
ORG 2
2 GRN
WHT/GRN 3
3 WHT/ORG
BLU 4
4 BLU
WHT/BLU 5
5 WHT/BLU
GRN 6
6 ORG
WHT/BRN 7
7 WHT/BRN
BRN 8
8 BRN
25 mm
Fold back the shield, wrap it onto
the inner vinyl sheath and cut it,
leaving approx. 9 mm.
Insert the cable into the modular
plug so that the folded part of the
shield enters into the plug housing.
The drain wire should be located
on the tab side of the jack.
Modular plug
[Straight cable]
1 WHT/ORG
2 ORG
3 WHT/GRN
4 BLU
5 WHT/BLU
6 GRN
7 WHT/BRN
8 BRN
2. WIRING
approx. 9 mm
Drain wire
WHT/ORG 1
ORG 2
WHT/GRN 3
BLU 4
WHT/BLU 5
GRN 6
WHT/BRN 7
BRN 8
2-5