Furuno FAR-2228 Installation Manual page 43

2. Attach the rubber foots (three for RCU-014, two for RCU-015/016) to the bottom
of the Control Unit as shown in the following figure.
3. Install the Control Unit at the desired location with self-tapping screws (local sup-
ply).
<RCU-031>
The Control Unit can be mounted with the KB fixture, which mounts the unit at an an-
gle.
1. Drill four pilot holes in the mounting location for mounting screws, referring to the
outline drawing at the back of this manual.
2. Secure the KB fixture (supplied) to the mounting location, using four self tapping
screws ( 5 20, supplied).
Note: Secure the KB fixture so that the cutout is located on the top side.
Cutout should be located
on the top side.
3. Attach a ground wire (IV-1.25sq, supplied locally) to the ground terminal at the
bottom of the unit.
Ground screw*
* : Use the screw that
is preattached to the
ground terminal.
4. Secure the Control Unit the KB fixture, using four binding screws (M5 20, sup-
plied).
KB fixing plate
Side view of Control Units
Ground
wire
1. INSTALLATION
Rubber Foot
Self tapping screw
(Ø5×20, 4 pcs)
KB fixture
1-17