Furuno FAR-2228 Installation Manual page 67

REAR REAR
Note: For the antenna cable RW-9600/6895/4873, connect the crimp-on lug
(that binds unused wires) together with the shield of the power line.
Destination of sub monitor cable
Signal line: TB803 through the locking wire saddle (A).
Coaxial cable: TB804 (B)
Shield of signal cable: Screw on fixing plate (C)
REAR REAR
9. DE-ICER INSTALLATION. See also "De-icer Kit Installation Instructions" (for TR-
UP radar, C32-01313), issued separately, for the de-icer not fitted at the factory.
If the de-icer is not provided, go to step 10.
Front cover w/de-icer,
inside view
C
TB801
Connect
shield for A
power line
Power line
B
D
Connect shield
for LAN cable
J821
B
TB804
Fasten conductor
with screw.
TB803
Signal line
DEICER Board (03P9573)
A
B
LAN cable
J821
B
NOTE: Do not use
crimp-on lug, to prevent
contact resistance from
Fasten shield
increasing.
with clamp.
Coaxial cable
B
C
A
[TEST] button
Voltage Setting
switch
TB901
2. WIRING
2-13