Table of Contents
Advertisement
3.12
Adjustments for LAN Adapter EC-1010
Before adjusting LAN adapter and updating program
The following tools are needed for programming LAN adapter:
• Ordinary serial line cross-cable to make connection from COM1 port to Connector J13 of
LAN Adapter (9 pins female – 9 pins female).
You need to set the jumpers of the LAN adapter to enable connector J13 and programming
mode.
To change J1 (CH 1) connector to J13 Connector for programming, set as below.
J17
J14
J15
To enable manual startup and programming, set as below.
J16
* See page 3-47 for parts location.
IP address agreement for LAN Adapter
Below is a table where you can find IP addresses for each device.
Device
First LAN adapter
Second LAN adapter
First chart processor
10.0.0.194
10.0.0.195
3. SETTING AND ADJUSTMENT
GND
TXP
RXP
INIT-GND
Second chart processor
10.0.0.196
10.0.0.197
3-43
Hide quick links:
Advertisement
Table of Contents
