Intelligent Hub (Option); Vdr Connection - Furuno FAR-2228 Installation Manual

2.12

Intelligent HUB (option)

Secure the LAN cables to the cable clamps on the HUB-3000 with cable ties (sup-
plied).
2.13

VDR Connection

The Processor Unit has the DVI-I port or the LAN port for connection of a VDR.
2.13.1 DVI-I (Analog RGB) port connection
• Use the optional RGB cable (DVI-BNCX5+GND-L2.0) to connect the VDR.
• The DVI-D port and DVI-I port have their own circuits. This prevents interruption of
the radar picture shown on the main monitor connected to the DVI-D port, if a fault
condition occurs at the DVI-I port.
• The Processor Unit continuously outputs video signals from its DVI-D and DVI-I
ports. The operator cannot stop the output.
2.13.2 LAN2 port connection
• Connect a VDR complied to IEC-61162-450 standards to the LAN2 port.
• If the [VDR LAN OUTPUT] setting is set to [ON], the screenshot (JPEG-format) is
output every 15 seconds through LAN2 port. See "[VDR LAN OUTPUT]"on page 3-
23.
• The output image at the same resolution as the DVI-D port.
• The LAN2 port and DVI-D port have their own circuits. This prevents interruption of
DVI-D port, if a fault condition occurs at the LAN2 port.
DPYC-1.5
LAN cable
LAN port
To gateway network (ECDIS, radar, etc.)
Attach the supplied LAN caps to unused connector
holes to comply with waterproofing standard IPX2.
Power Fail
Power port
DPYC-1.5
No use.
Cable clamp
2. WIRING
Ground wire
(IV-1.25sq.,
supplied)
2-73