Furuno FAR-2228 Installation Manual page 66

2. WIRING
If applicable, unfasten the two screws fixing the cable clamp for the sub monitor
and de-icer power cable, then pass the cables through the cable entrance.
Remove two screws to remove the cable
clamp for the sub monitor and de-icer power
cable.
Note: The dummy plug is provided to insert into the unused cable slot. Insert the
plug for waterproofing.
6. Pass the cables through their respective locking wire saddles in the chassis from
the cable entrance.
Note: Make sure to pass the cable through the specified locking wire saddle.
7. Re-mount the transceiver unit then reconnect the connectors for the motor (J803,
J804 and J808).
8. Attach the appropriate WAGO connectors (pre-attached) to the appropriate ca-
bles, and then connect the antenna and sub monitor cables to the RF-TB Board
as shown in the following figure. For how to connect the WAGO connector, see
"WAGO connector" on page 2-6. For pin arrangement, see the interconnection di-
agram at the back of this manual.
Note 1: Make sure to pass the cable through the specified locking wire saddle.
Note 2: A terminal opener is provided on the RF-TB Board.
Destination of antenna cable
Power line: TB801 through the locking wire saddles (A, two places).
LAN cable: J821 through the locking wire saddles (B, two places).
Shield of power line: Screw on fixing plate (C)
Shield of LAN cable: Screw (D)
2-12
Locking wire saddle Locking wire saddle
for de-icer cable for de-icer cable
REAR REAR
De-icer power cable
Sub monitor cable
Cable entrance Cable entrance
Locking wire saddle for antenna Locking wire saddle for antenna
and sub monitor cables and sub monitor cables