Furuno FAR-2228 Installation Manual page 118

2. WIRING
3. Fasten the cables to the post part of the plates with cable ties (local supply).
Note: Be sure the vinyl sheath on the post.
Spacer
4. Pass the cables to the TB board 03P9648 and
03P9562 through the locking wire saddles (A, B and
C) in the figure shown right.
For the cables on the upper plate, use locking wire
saddles (A and B).
For the cables on the lower plate, use locking wire
saddles (A, B and C).
5. Connect the connectors to the TB Board. referring to
the interconnection diagram.
J508
Connect cable for USB mouse or USB keypad (local supply, max. 5 m).
Note: Do not connect a USB device other than mouse.
J503
Connect LAN cable
for antenna cable.
6. Connect the ground wires of cables to the near ground terminals on the plates.
Connection of cables for Control Unit
1. Unfasten the four bolts, indicated with dashed circles below, to remove the upper
plate of the cable clamp.
2-64
Cable tie
Ground termimal
Vinyl
sheath
Cable tie
Serial cable
Upper plate
J510/J511
Connect cable for sub
monitors of ECDIS.
Cable tie
J620 J617
(AD-10, GYRO) (LOG)
J618 (AMS serial)
J619 (ECDIS)
J613 (AMS contact)
J608 (Antennna)
Ground termimal
Shield
Vinyl
sheath
Sub monitor cable
Lower plate
03P9648
( A )
03P9652
( B )
( C )
J616 J614
(GPS) (HDG)
J615 (AIS)
J611
(Control Unit)
J621
(RS-232C for brill control)