Furuno FAR-2228 Installation Manual page 85

Destination of Antenna cable:
Power line: TB801 through the locking wire saddle (A)
LAN cable: J821 through the locking wire saddles (B, two places)
Shield of power line: Screw (C)
Shield of LAN cable: Screw (D)
REAR REAR
REAR REAR
Note: For the antenna cable RW-9600/6895/4873, connect the crimp-on lug
(that binds unused wires) together with the shield of the power line.
Destination of sub monitor cable
Note: Remove (or Loosen) four bolts as shown in the following figure to re-
move the RF-TB Board from the RF unit.
Signal line: TB803 through the locking wire saddle (A), see the figure for the
"Destination of Antenna cable:"
Coaxial cable: TB804 (B)
Shield of signal line: Screw (C)
REAR REAR
( C )
Connect shield for power line
TB801
Power line
( B )
LAN cable
( B )
( D )
Connect shiled
J821
for LAN cable
( B )
TB804
Fasten conductor
with screw.
Remove Remove
( A )
NOTE: Do not use
crimp-on lug, to prevent
contact resistance from
Fasten shield
increasing.
with clamp.
( B )
TB803
2. WIRING
Loosen Loosen
( C )
2-31