Furuno FAR-2228 Installation Manual page 105

Connection of Power cable
1. Loosen four screws on the front plate, then unfasten two screws on the cable
clamp to set the power cable.
Cable clamp Cable clamp
2. Set the power cable on the cable entrance, and fasten the sheath part of the pow-
er cable with the cable clamp. For the clamp position, see "DPYC-2.5 cable (for
Power)" on page 2-48.
3. Remove the plastic cover on TB1 to pass the power cable.
4. Connect the cable to TB1 with the pre-attached crimp-on lugs, referring to the wir-
ing label near TB1.
5. Remount the plastic cover and the front cover, then clamp the power cable on the
sheath.
Connection of cable for Processor Unit
1. Connect the lines of the cable to the appropriate WAGO connectors (TB704), re-
ferring to the interconnection diagram at the back of this manual.
2. Set the cable for Processor Unit on
the upper cable entrance as shown
below, and fasten the armor part of
the cable with the cable clamp.
Front Plate Front Plate
TB1 TB1
Plastic cover Plastic cover
Cable entrance for power cable Cable entrance for power cable
Cable for Processor Unit
2. WIRING
Wiring label
2-51