ZyXEL Communications 43222612 User Manual page 478

Figure 360 Switching > Link Aggregation > Link Aggregation Control Protocol
The following table describes the labels in this screen.
Table 250 Switching > Link Aggregation > Link Aggregation Control Protocol
LABEL DESCRIPTION
Link
Note: Do NOT configure this screen unless you want to enable dynamic link
Aggregation
aggregation.
Control
Protocol
Active Set this switch to ON to enable Link Aggregation Control Protocol (LACP).
System Priority LACP system priority is a number between 1 and 65535. The switch with the lowest system priority
(and lowest port number if system priority is the same) becomes the LACP "server". The LACP
"server" controls the operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregation Control Protocol (LACP). The smaller the number, the higher the priority
level.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple ports.
LACP Active Select this option to enable LACP for a trunk.
Port This field displays the port number.
Chapter 61 Switching
GS2220 Series User's Guide
478