ZyXEL Communications 43222612 User Manual page 352

Figure 265 Advanced Application > OAM > OAM Configuration
The following table describes the fields in the above screen.
Table 180 Advanced Application > OAM > OAM Configuration
LABEL DESCRIPTION
Active Select this option to enable Ethernet OAM on the Switch.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable Ethernet OAM on this port.
Clear this check box to disable Ethernet OAM on the port.
Mode Specify the OAM mode on the port.
Select Active to allow the port to issue and respond to Ethernet OAM commands.
Select Passive to allow the port to respond to Ethernet OAM commands.
Remote Loopback Select this check box to enable the remote loopback feature on the port. Otherwise, clear
Supported the check box to disable it.
Remote Loopback Select this check box to set the Switch to process loopback commands received on the
Ignore-Rx port. Otherwise, clear the check box to have the Switch ignore loopback commands
received on the port.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Chapter 39 OAM
GS2220 Series User's Guide
352