Ipv6 Static Binding Setup - ZyXEL Communications 43222612 User Manual

28.5 IPv6 Static Binding Setup

Use this screen to manually create an IPv6 source guard binding table entry and manage IPv6 static
bindings. Static bindings are uniquely identified by the source IPv6 address / prefix. Each source IPv6
address / prefix can only be in one static binding. If you try to create a static binding with the same
source IPv6 address / prefix as an existing static binding, the new static binding replaces the original
one. To open this screen, click Advanced Application > IP Source Guard > IPv6 Static Binding Setup.
Figure 211
The following table describes the labels in this screen.
Table 133 Advanced Application > IP Source Guard > IPv6 Static Binding Setup
LABEL
IPv6 Static Binding
Source Address
MAC Address
VLAN
Port
Add
Cancel
Clear
Index
Source Address
MAC Address
VLAN
Port
Chapter 28 ARP Inspection
Advanced Application > IP Source Guard > IPv6 Static Binding Setup
DESCRIPTION
Enter the IPv6 address or IPv6 prefix and prefix length in the binding.
Enter the source MAC address in the binding. If this binding does not check this field, select
Any.
Note: You cannot choose Any for all three of MAC Address, VLAN and Port. You
must fill in at least one.
Enter the source VLAN ID in the binding. If this binding does not check this field, select Any.
Specify the ports in the binding. If this binding has one port, select the first radio button and
enter the port number in the field to the right.
Click this to create the specified static binding or to update an existing one.
Click this to reset the values above based or if not applicable, to clear the fields above.
Click this to clear the fields above.
This field displays a sequential number for each binding.
This field displays the IPv6 address or IPv6 prefix and prefix length in the binding.
This field displays the source MAC address in the binding. If the entry is blank, this field will not
be checked in the binding.
This field displays the source VLAN ID in the binding. If the entry is blank, this field will not be
checked in the binding.
This field displays the port number in the binding. If this field is blank, the binding applies to all
ports.
GS2220 Series User's Guide
281