Mst Region; Mst Instance - ZyXEL Communications 43222612 User Manual

Table of Contents

With MSTP, VLANs 1 and 2 are mapped to different spanning trees in the network. Thus traffic from the

two VLANs travel on different paths. The following figure shows the network example using MSTP.

Figure 142 MSTP Network Example

13.10.2 MST Region

An MST region is a logical grouping of multiple network devices that appears as a single device to the

rest of the network. Each MSTP-enabled device can only belong to one MST region. When BPDUs enter

an MST region, external path cost (of paths outside this region) is increased by one. Internal path cost (of

paths within this region) is increased by one when BPDUs traverse the region.

Devices that belong to the same MST region are configured to have the same MSTP configuration

identification settings. These include the following parameters:

• Name of the MST region

• Revision level as the unique number for the MST region

• VLAN-to-MST Instance mapping

An MST Instance (MSTI) is a spanning tree instance. VLANs can be configured to run on a specific MSTI.

Each created MSTI is identified by a unique number (known as an MST ID) known internally to a region.

Thus an MSTI does not span across MST regions.

The following figure shows an example where there are two MST regions. Regions 1 and 2 have two

spanning tree instances.

Chapter 13 Spanning Tree Protocol

GS2220 Series User's Guide