ZyXEL Communications 43222612 User Manual page 73

Table 18 Navigation Panel Links (Standard Mode) (continued)
LINK DESCRIPTION
Loop Guard This link takes you to a screen where you can configure protection against network loops that
occur on the edge of your network.
VLAN Mapping This link takes you to screens where you can configure VLAN mapping settings on the Switch.
Layer 2 Protocol This link takes you to a screen where you can configure L2PT (Layer 2 Protocol Tunneling)
Tunneling settings on the Switch.
PPPoE This link takes you to screens where you can configure how the Switch gives a PPPoE
termination server additional subscriber information that the server can use to identify and
authenticate a PPPoE client.
Errdisable This link takes you to screens where you can view errdisable status and configure errdisable
settings in CPU protection, errdisable detect, and errdisable recovery.
Vlan Isolation This link takes you to a screen where you can block traffic between ports in a VLAN on the
Switch.
Green Ethernet This link takes you to a screen where you can configure green Ethernet settings in EEE, auto
power down, and short reach for each port.
LLDP This link takes you to screens where you can configure LLDP settings.
Anti-Arpscan This link takes you to screens where you can enable anti-arpscan on the Switch and ports, and
view the port state. You can also create trusted hosts, view blocked hosts and unblock them.
BPDU Guard This link takes you to screens where you can enable BPDU guard on the Switch and ports, and
view the port state.
OAM This link takes you to screens where you can enable Ethernet OAM on the Switch, view the
configuration of ports on which Ethernet OAM is enabled and perform remote-loopback tests.
ZULD This link takes you to screens where you can enable ZULD on a port and configure related
settings.
Auto PD For PoE models.
Recovery
This link takes you to a screen where you can enable and configure Auto PD Recovery on the
Switch.
IP Application
Static Routing This link takes you to a screen where you can configure static routes. A static route defines how
the Switch should forward traffic by configuring the TCP/IP parameters manually.
DiffServ This link takes you to screens where you can enable DiffServ, configure marking rules and set
DSCP-to-IEEE802.1p mappings.
DHCP This link takes you to screens where you can configure the DHCP settings.
ARP Setup This link takes you to screens where you can configure the ARP learning settings for each port.
Management
Maintenance This link takes you to screens where you can perform firmware and configuration file
maintenance as well as reboot the system.
Access Control This link takes you to screens where you can change the system login password and configure
SNMP and remote management.
Diagnostic This link takes you to a screen where you can ping IP addresses, run traceroute, test ports and
show the Switch's location.
System Log This link takes you to a screen where you can view system logs.
Syslog Setup This link takes you to a screen where you can setup system logs and a system log server.
Cluster This link takes you to screens where you can configure clustering management and view its
Management status.
MAC Table This link takes you to a screen where you can view the MAC addresses (and types) of devices
attached to what ports and VLAN IDs.
Chapter 4 Web Configurator
GS2220 Series User's Guide
73