ZyXEL Communications 43222612 User Manual page 190

Figure 149 Advanced Application > Link Aggregation > Link Aggregation Setting
The following table describes the labels in this screen.
Table 79 Advanced Application > Link Aggregation > Link Aggregation Setting
LABEL DESCRIPTION
Link This is the only screen you need to configure to enable static link aggregation.
Aggregation
Setting
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple ports.
Active Select this option to activate a trunk group.
Criteria Select the outgoing traffic distribution type. Packets from the same source and/or to the same
destination are sent over the same link within the trunk. By default, the Switch uses the src-dst-mac
distribution type. If the Switch is behind a router, the packet's destination or source MAC address
will be changed. In this case, set the Switch to distribute traffic based on its IP address to make
sure port trunking can work properly.
Select src-mac to distribute traffic based on the packet's source MAC address.
Select dst-mac to distribute traffic based on the packet's destination MAC address.
Select src-dst-mac to distribute traffic based on a combination of the packet's source and
destination MAC addresses.
Select src-ip to distribute traffic based on the packet's source IP address.
Select dst-ip to distribute traffic based on the packet's destination IP address.
Select src-dst-ip to distribute traffic based on a combination of the packet's source and
destination IP addresses.
Port This field displays the port number.
Group Select the trunk group to which a port belongs.
Note: When you enable the port security feature on the Switch and configure port
security settings for a port, you cannot include the port in an active trunk group.
Chapter 17 Link Aggregation
GS2220 Series User's Guide
190