Table of Contents
Advertisement
12 February 1992
2.4 KEY COUNTER HOLDER INSTALLATION (OPTION)
[H]
[F]
CAUTION: Make sure that the main switch is turned off.
[Machines without LCT]
1. Remove the rear cover [A] (remove 2 screws and loosen 2 screws).
2. Open the by-pass feed table and remove the right upper cover [B] (4
screws).
3. Remove the right lower cover [C] (2 screws).
--- Go to step 4.
[Machines with LCT]
1. Lift up the LCT top cover [D] and remove the LCT front cover [E]
(1 screw).
2. Remove the right front lower cover [F] (2 screws).
--- Go to step 4.
[Common procedure]
4. Remove the shorting connector [G] from the key counter connector.
5. Remove the key counter cover [H] from the key counter holder bracket
(2 screws).
[D]
[G]
[E]
3-19
COPIER INSTALLATION
[G]
[H]
[A]
[B]
[C]
Advertisement
Table of Contents
