Table of Contents
Advertisement
COPIER INSTALLATION
[C]
21. Install the black development unit [A] in the copier, and remove the cover
sheet [B] from the toner supply unit.
•
NOTE:
When installing the development unit, be sure that the
development unit rail is placed directly on the development
unit guide rail.
•
Make sure that the development release lever [C] is in its
original position after the development unit is set.
22. Shake the toner cartridge [D] well from side to side. While pushing the
toner cartridge in, insert it halfway into the holder with the seal [E] up.
23. As you peel off the seal, insert the cartridge completely. While pushing
the toner cartridge in, turn it counterclockwise until it stops.
24. Slide out the charge corona unit [F] until it is fully extended and push it
back in to the original position. Repeat this action several times.
[A]
3-6
[C]
[B]
10 July 1992
[E]
[D]
[F]
Advertisement
Table of Contents
