Nexcom FTA 5180 Series User Manual page 42

Chapter 3: BIOS Setup
Data Bits
The options are 7 and 8.
Parity
A parity bit can be sent with the data bits to detect some transmission errors.
Even Parity bit is 0 if the number of 1's in the data bits is even.
Odd Parity bit is 0 if number of 1's in the data bits is odd.
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the
beginning). The standard setting is 1 stop bit. Communication with slow
devices may require more than 1 stop bit.
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data
and the receiving buffers are full, a "stop" signal can be sent to stop the
data flow.
VT-UTF8 Combo Key Support
Enables or disables VT-UTF8 combo key support.
Recorder Mode
When this field is enabled, only text will be sent. This is to capture the
terminal data.
Resolution 100x31
Enables or disables extended terminal resolution.
Putty Keypad
Selects the Putty keyboard emulation type.
Copyright © 2022 NEXCOM International Co., Ltd. All Rights Reserved.
PCI Subsystem Settings
This section is used to configure the PCI.
Advanced
PCI Bus Driver Version
PCI Devices Common Settings:
Above 4G Decoding
SR-IOV Support
PCI Express Settings
►
PCI Express GEN 2 Settings
►
Version 2.22.1283. Copyright (C) 2022 AMI
Above 4G Decoding
Enables or disables decoding of 64-bit devices in 4G address space.
SR-IOV Support
Enables or disables SR-IOV support
29
Aptio Setup - AMI
A5.01.27
Enables or Disables
64bit capable Devices
to be Decoded in Above
4G Address Space (Only
[Enabled]
if System Supports 64
[Enabled]
bit PCI Decoding).
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
FTA5180 Series User Manual