At-X9Em/Xt4 Card; Figure 17: Optional At-X9Em/Xt4 Card; Table 16: Twisted Pair Cable For The At-X9Em/Xt4 Card - Allied Telesis AT-x930-28GTX Installation Manual

AT-x9EM/XT4
Card
For installation instructions for the card and VCStack, refer to x930 Series
Installation Guide for Virtual Chassis Stacking.
This card adds four additional networking ports to the switch, The ports
can operate at either 1Gbps (1000Base-T) or 10Gbps (10Base-T) and
have RJ-45 connectors for twisted pair cables. The card is shown in
Figure 17.
Figure 17. Optional AT-x9EM/XT4 Card
Note
The card requires version 5.4.5-2 or later of the management
software. The instructions in "Verifying Support for Hardware
Options" on page 132 explain how to determine the version number
of the software on the switch.
The cable requirements for the ports are given in Table 16.
Table 16. Twisted Pair Cable for the AT-x9EM/XT4 Card
Port Speed
1Gbps
10Gbps
x930 Series Installation Guide for Stand-alone Switches
Cable Type
Standard TIA/EIA 568-A-
compliant Category 5 or
TIA/EIA 568-B-compliant
Enhanced Category 5 (Cat
5e) shielded or unshielded
cabling
Standard TIA/EIA-568-C.1
compliant Category 6a (Cat
6a) shielded or unshielded
cabling
Maximum
Operating Distance
100 m (328 ft)
100 m (328 ft)
53