Cylnder Jog Operation - Mitsubishi RV-2F Series Instruction Manual

2 Unpacking to Installation
(5) jog operation
CYLNDER
Select cylindrical jog mode
<CURRENT> JOINT
J1: +0.00
J2: +0.00
J3: +90.00
J4: +0.00
TOOL JOG
XYZ
Set jog speed
<CURRENT> JOINT
J1: +0.00
J2: +0.00
J3: +90.00
J4: +0.00
TOOL JOG
XYZ
Moving along an arc centering on the Z axis
Assuming that the current position is on an arc centering on the Z axis, the robot moves along that arc.
・ When the[+X (J1)] keys are pressed, the robot will expand in the radial direction.
When the[-X (J1)] keys are pressed, Contract in the radial direction.
・ When the[+Y (J2)] keys are pressed, the robot will move along the arc in the plus direction.
When the[-Y (J2)] keys are pressed, Move in the minus direction.
・ When the[+Z (J3)] keys are pressed, the robot will move along the Z axis plus direction.
When the[-Z (J3)] keys are pressed, Move along the minus direction.
Confirming the operation
2-33
100% M1 T0
J5: +0.00
J6: +0.00
:
:
3-XYZ CYLNDR
⇒
CYLNDER jog mode
100% M1 T0
J5: +0.00
J6: +0.00
:
:
3-XYZ CYLNDR
⇒
Setting the speed
Vertical
Radius
－Ｙ
＋X
[JOG] Press the key and display the jog screen.
("JOG" is displayed on the screen bottom)
Check that the "CYLNDER" in jog mode is
displayed on the screen.
If other jog modes are displayed, please press the
～
function key corresponding to the "CYLNDER."
(If the jog mode which he wishes under the
screen is not displayed, it is displayed that the
[FUNCTION] key is pressed)
If it finishes jog operation, press the [JOG] key
again, or function key which correspond to
"close."
Whenever it presses the key of [OVRD ↑ ], the
override goes up. Conversely, if the [OVRD ↓ ]
key is pressed, it will go down.
The current setting speed is displayed on screen
upper right, and "STATUS NUMBER" of the
controller.
Set the override to 10% here for confirmation
work
＋Z
Arc
－Ｘ
＋Y
* The direction of the frange will not change.
－Z