Cnr-Four Corner Geometry Correction; Con-Contrast - Christie GS Series Technical Reference

Examples
Set the color saturation value to 50:
(CLR 50)
CNR–Four Corner Geometry Correction
Fits an image in an area defined by x and y coordinates.
This command is not available if a Dual Processor Warp module (DPWM) is not installed.
Commands
Command Description
CNR+TLCX <value> Applies a top left horizontal adjustment. (Write-only)
CNR+TLCY <value> Applies a top left vertical adjustment. (Write-only)
CNR+TRCX <value> Applies a top right horizontal adjustment. (Write-only)
CNR+TRCY <value> Applies a top right vertical adjustment. (Write-only)
CNR+BLCX <value> Applies a bottom left horizontal adjustment. (Write-only)
CNR+BLCY <value> Applies a bottom left vertical adjustment. (Write-only)
CNR+BRCX <value> Applies a bottom right horizontal adjustment. (Write-only)
CNR+BRCY <value> Applies a bottom right vertical adjustment. (Write-only)
Examples
Set the top-left vertical adjustment value to 20:
(CNR+TLCY 20)
CON–Contrast
Sets the image white level by adjusting the gain applied to the input signal.
This command adjusts the degree of difference between the lightest and darkest parts of the image.
GS Series Serial API Commands Technical Reference
020-000814-01 Rev. 1 (06-2015)
Serial API commands
Values
0 to 140
0 (Default)
0 to 80
0 (Default)
0 to 140
0 (Default)
0 to 80
0 (Default)
0 to 140
0 (Default)
0 to 80
0 (Default)
0 to 140
0 (Default)
0 to 80
0 (Default)
19