Crv-Curve Geometry Correction - Christie GS Series Technical Reference

Commands
Command Description
CON <value> Sets the white level value.
Examples
Set the white level value to 50:
(CON 5)
CRV–Curve Geometry Correction
Corrects the symmetry of a constant radius horizontal or vertical curve by modifying the top and
bottom of the image.
Note the following when using this command:
• Compound curves are not supported.
• The projector should be mounted perpendicular to the chord of the curve within the offset
limitation of the lens used (ideally on axis).
• There is no tilt correction.
• This command is not available if a Dual Processor Warp module (DPWM) is not installed.
Commands
Command Description
CRV+TARC <value> Applies a top arc adjustment. (Write-only)
CRV+BARC <value> Applies a bottom arc adjustment. (Write-only)
CRV+LARC <value> Applies a left arc adjustment. (Write-only)
CRV+RARC <value> Applies a right arc adjustment. (Write-only)
Examples
Set the top arc adjustment value to 20:
(CRV+TARC 20)
GS Series Serial API Commands Technical Reference
020-000814-01 Rev. 1 (06-2015)
Serial API commands
Values
0 to 100
Values
0 to 300
150 (Default)
20